Norco BIS-6330A, Руководство пользователя

Страница: 24 / 64

BIS-6330A
Digital Signage Player
12
Chapter 3 Installation Instructions
Before installing your computer accessories, please keep the following two points in mind:
1. Please make sure that your computer does not connect to power supply .
2. Please wear anti-static wristband/gloves when touching integrated circuit components (e.g.
RAM, etc).
3.1 Jumper Setting
Please refer to the following jumper setting guide before installing your hardware devices.
Remark: How to identify PIN1 of jumper and interface: Please observe the word mark of plug
socket, it will use “1” or bold line or triangular symbols; and please look at the back of PCB.
Each interface weld spot has a square point, that is PIN 1; and PIN1 of all the jumpers has a
white arrow beside it..
3.1.1 CMOS Content Clear/ Hold Jumper Setting
（
JCC
）
CMOS powered by onboard button battery. Clear CMOS will lead to a permanent elimination of
the previous system setting and back to the original (default setting) system setting.
Steps :
（
1
）
Turn off the computer, disconnect the power supply
（ 2 ） Use jumper cap short JCC Pin 1 and Pin 2 for 5~6 sec ， Then restore the default setting of
Pin2 and Pin 3
（
3
）
Turn on the computer, then press F1 key into the BIOS setting and reload
the optimized default value.
（
4
）
Save and exit setting.