8
21
OPERATING THE REMOTE CONTROL
Notes:
Do not direct the remote sensor toward any
light source, such as direct sunlight or a
strong fluorescent light, as it may cause
the unit to not operate correctly.
When other remote controls are used
nearby or when the remote is used near
equipment using infrared rays, interference
may occur.
Placing an object on the remote control may
cause it to inadvertently depress a button,
changing a function and shortening battery
life.
Do not glaze the front of the DVD receiver
with colored glass, as it may cause
interference with normal operation of the
controller.
Make sure there is no barrier between the
remote control and remote sensor, as it
could prevent the unit from receiving the
signal.
Do not spill water or put wet items on the
remote control.
Never disassemble remote control.
BATTERIES
INCORRECT USE OF BATTERIES MAY
CAUSE THEM TO LEAK, CORRODE OR EXP
LODE.
This turns the center speaker on or off.
Rear Speaker
Follow the instructions above in DVD Menu
Setup in combination with the desired option
from graphic below.
This turns the rear speaker on or off.
ON
OFF
SPEAKER SETUP
CENTER SPEAKER
DOWNMIX
REAR
SUB WOOFER
CETR DELAY
REAR DELAY
TEST TONE
MAIN PAGE
CETR
ON
OFF
SPEAKER SETUP
REAR SPEAKER
DOWNMIX
CETR
SUB WOOFER
CETR DELAY
REAR DELAY
TEST TONE
MAIN PAGE
REAR
ON
OFF
SPEAKER SETUP
WOOFER SPEAKER
DOWNMIX
CETR
REAR
CETR DELAY
REAR DELAY
TEST TONE
MAIN PAGE
SUB WOOFER
A Dolby Digital 3-D surround sound system
ideally delivers realistic sound effects,
enhancing the enjoyment of viewers. Some
amplifying systems need help in this regards.
Delaying the sound output of the central and
rear speakers is a way to overcome this problem.
The center delay is used to set the delay time
of the center speaker.
SPEAKER SETUP
CENTER DELAY
5ms
3ms
1ms
OFF
DOWNMIX
CETR
REAR
SUB WOOFER
REAR DELAY
TEST TONE
MAIN PAGE
CETR DELAY
Rear Delay
Follow the instructions above in DVD Menu
Setup in combination with the desired option
from graphic below.
The sound output of the rear speakers is
delayed to ensure the best quality Dolby Digital
3-D surround sound system is delivered. (See
Center Delay for details.)
SPEAKER SETUP
REAR DELAY
15ms
9ms
3ms
OFF
DOWNMIX
CETR
REAR
SUB WOOFER
CETR DELAY
TEST TONE
MAIN PAGE
REAR DELAY
Test
Follow the instructions above in DVD
Menu Setup in combination with the desired
option from graphic below.
This tests the sound coming from each
speaker in the system. The speaker being
tested is indicated in the lower left corner of
the screen.
ON
OFF
SPEAKER SETUP
TEST TONE
DOWNMIX
CETR
REAR
SUB WOOFER
CETR DELAY
REAR DELAY
MAIN PAGE
TEST TONE
SYSTEM SETUP
Subwoofer
Follow the instructions above in DVD Menu
Setup in combination with the desired option
from graphic below.
This turns the subwoofer speaker on or off.
Center Delay
Follow the instructions above in DVD Menu
Setup in combination with the desired option
from graphic below.
Battery Installation
1. Push down and out on the battery
Compartment cover to remove it.
2. Insert the two AAA batteries into the battery
compartment of the remote control, making
sure the + and - signs on the batteries and
inside the battery compartment match up.
3. Replace the battery compartment cover.
Notes:
Do not mix batteries from different manu-
facturers, nor old ones with new.
If the remote control will not be used for an
extended period of time, remove the
batteries to prevent damage-causing
corrosion.
Remove dead batteries immediately to
prevent damage-causing corrosion.
If battery leakage occurs, wipe the battery
liquid from the battery compartment, then
replace both batteries.
Always replace both batteries at the same
time, using new, fully charged batteries.
Life expectancy of batteries may vary
depending on amount of use.
Using the Remote Control
Point the remote control at the remote
sensor on the DVD receiver. When the signal is
received from the remote, the unit will function
accordingly. The remote will operate to
approximately 16' from the remote sensor at an
angle of around 30 each direction.
"
"
1. Push down and out on the battery
Compartment cover to remove it.
2. Insert the two AAA batteries into the battery
compartment of the remote control, making
sure the + and - signs on the batteries and
inside the battery compartment match up.
3. Replace the battery compartment cover.
Do not mix batteries from different manu-
facturers, nor old ones with new.
If the remote control will not be used for an
extended period of time, remove the
batteries to prevent damage-causing
corrosion.
Remove dead batteries immediately to
prevent damage-causing corrosion.
If battery leakage occurs, wipe the battery
liquid from the battery compartment, then
replace both batteries.
Always replace both batteries at the same
time, using new, fully charged batteries.
Life expectancy of batteries may vary
depending on amount of use.
Point the remote control at the remote
sensor on the DVD receiver. When the signal is
received from the remote, the unit will function
accordingly. The remote will operate to
approximately 16' from the remote sensor at an
angle of around 30 each direction.
Battery Installation
Using the Remote Control
Notes:
