NORBAR TORQUE TOOLS LTD, Wildmere Road, Banbury, Oxfordshire, OX16 3JU, UNITED KINGDOM
Tel: + 44 (0)12965 753600
Email: [email protected] | Website:
www.norbar.com
4.
Ensure displayed Torque Target is correct. Target will be remembered from the last use.
To quickly alter the target shown press and hold either the up or down arrows and
press to confirm.
To change targets press the button to exit the run screen and bring up the below menu.
Then select the targets icon (highlighted above) and press to confirm.
Use the up and down arrow keys to highlight required target and press to
enter target setup.
Alter the target’s value using the up and down arrows and confirm by pressing .
Then press the button twice to return to the run screen.
5.
Rotate the handle into a convenient position relative to the reaction bar. Fit the tool onto the
fastener to be tightened with the reaction bar adjacent to the reaction point.
NOTE:
The wrench/socket should be engaged to the full depth of the nut/bolt to
transmit maximum torque and to prevent damage from overloading the
wrench and damaging the corners of the nut/bolt or socket.
IMPORTANT:
BE AWARE OF HAND AND FINGER PLACEMENT,
AVOID ALL OPERATION HAZARDS WHEN
POSITIONING OR USING EQUIPMENT.
6.
Adopt a posture to counteract normal or unexpected movement of the tool due to reaction
forces.
7.
To run tool press trigger and ‘safe to start’ button simultaneously (as demonstrated
overleaf)
to slowly bring reaction bar into contact with the reaction point. The ‘safe to start’
button is only required to start the tool, not for continued running.
IMPORTANT:
BRINGING THE REACTION BAR INTO CONTACT AT SPEED CAN
LEAD TO INCREASED OPERATOR DANGER, FASTENER DAMAGE,
REACTION POINT DAMAGE AND TORQUE INACCURACIES,
ESPECIALLY ON HIGH TORQUE RATE JOINTS.
8.
Once the reaction bar is safely in place release both the ‘safe to start’ button and trigger and
wait for half a second.
9.
Fully press trigger (and ‘safe to start’ button), keep trigger fully pressed until tool stops, then
release trigger.
10. Press to return to the run screen.
