3
FUNCTIONAL DESCRIPTION
A – LED display for each 14V and 18V pair
SPECIFICATIONS
Battery Charger Specifications
(Norbar CTC123 (60335))
Input
100-240VAC, 50/60Hz
Output
Battery 18V DC 5A
Battery 7.2 / 14.4V DC 3A
USB 5V DC 1A
Weight
1.4 kg (3.0 lb)
Safety Standards
EN 60335-1 & EN 60335-2-29
EMF Standards
EN 62233
EMC Standards
EN 55014-1, EN 55014-2,
EN 61000-3-2 & EN 61000-3-3
Charging Temperature Range
0°C (32°F) to
45°C (113°F)
NOTE: If the equipment is used in a manner not
specified by the manufacturer, the
protection provided by the equipment may
be impaired.
Symbology
V
Refer to
Operator’s
Manual
Volts
Direct
Current
CE
MARK
Do not
place in
general
waste
Battery Pack Specifications
(Norbar EBP 60334)
Type
Lithium-Ion
Voltage
18 VDC (3.6V X 5 cells)
Weight
0.75 kg (1.65 lb)
Charge Time
70 min (approximately)
Life
1,000 cycles (Note: 1 cycle = 1
charge and 1 discharge)
Capacity
5.0 A•H
Discharge Temperature Range
20°C (-4°F) to
60°C (140°F)
OPERATION
AC Cord and Plug Requirement
1. Cord rating
— 120V, 10A, Type: SPT-2, 18AWG.
— 240V, 2.5A, Type: H03VVH2-F, 2X0.75mm or
equivalent.
2. Cord length: min.1.8m (6 feet); max. 6.1m (20
feet) including output cord.
3. Cord type: must comply with requirement set out
by the safety approval / certification
Organization of each country of use.
Battery Charging
1. If charger is supplied with a separate charger
cord, plug cord into charger.
2. Plug the other end of charger into the AC power
source.
3. Insert battery pack in charger. Press lightly on
battery pack until it stops. The charger is
equipped with a 4-LED fuel gauge that indicates
25%, 50%, 75% and 100% state of charge.
When the battery makes contact, all 4 green
LEDs on the fuel gauge of the charger will flash
twice and then the charger will step through the
Figure 2: Inserting the Battery Pack
into the Charger
Figure 1: Battery Charger
