NORAUTO 46866, Инструкция по эксплуатации

Страница: 98 / 110

98
DIRECTION SWITCH
The Impact Wrench can move in two
directions: Forward “FWD” for tightening,
Reverse “REV” for loosening.
FWD
FWD
REV
FORWARD/REVERSE LEVER
REV
REMOVING LUG NUTS
CAUTION Use 12 Volt DC power ONLY. Any other voltage will damage the tool.
1. Park vehicle in a safe outside location
away from moving traffic. Always set
the vehicle parking brake and block the
wheels so the vehicle will not move while
impact wrench is in use. In some cars, the
ignition switch needs to be set to “ON” to
power the cigarette Lighter outlet.
2. Plug the 12 Volt plug-in into the vehicle’s
12 Volt power supply. Verify that the
impact wrench LED light turns on.
IMPACT WRENCH PLUG
VEHICLE 12V OUTLET
NOTE This Impact Wrench does not work immediately like air-operated or
220V wrenches. The tool must built up inertia before striking a blow. This hesitation is
normal and does not mean that the tool is broken.
3. Pick an impact socket that will fit the wheel lug nut. Press the socket onto the anvil. NEVER
use sockets that are not specifically designed for use with impact wrenches.
4. Place a jack under the lift point for the wheel to be removed and raise the vehicle.
5. Support the vehicle by placing jack stands at locations recommended by the vehicle
manufacturer.
WARNING Do not get under the vehicle without jack stands. Jacks are not
designed to maintain heavy loads for long periods of time.
6. Set the Directional Lever to “REV” and carefully loosen the lug nuts. Remove in the order
recommended by the manufacturer.
7. If the Impact Wrench cannot loosen the lug nut, use a breaker bar (not included) to break the
nut loose before trying again.