39
EN
WIRING DIAGRAM
Connect to battery anode
Connect to automatic antenna
Rear right loudspeaker
Front right loudspeaker
Yellow
Blue
Purple
Purple black
Gray
Black gray
Red
Green
Green black
White
White black
Black
Connect to battery cathode
10A fuse
Connect to
the car key
Rear left
loudspeaker
Front left
loudspeaker
Front left audio
output 1 (white)
Front left audio
output 2 (white)
Front right audio
output 2 (red)
Front right audio
output 1 (red)
SCHEMATIC DIAGRAM OF INSTALLATION AND DISASSEMBLY
1.
Schematic diagram of installation
• The host will be placed as per the installation position before installing the host, which
shall be connected to the corresponding horn wire and power Stator line.
• The host can be fixed after the host running effect is satisfactory.
2.
Install the host
• Install the bracket on the instrument panel of the vehicle and bend the part of the card
position of the bracket.
• Connect the power line and horn wire, and fix the stator on the vehicle. Push main
engine into bracket and tighten nuts
3.
Uninstall the host
Loosen the fixing nuts of stators; Insert two pieces of disassembly keys into the gaps on
the left and right sides at the same time, hook the disassembly key to the host and pull it
out gently to make the machine separate from the bracket. Then, remove the power line
and horn wire, and unplug the antenna plug.
MAINTENANCE
1.
Cleaning the unit:
Wipe off the dirt on the panel with a dry silicon or soft cloth. Failure
to observe this precaution may result in damage to the monitor or unit.
2.
Cleaning the connector:
Wipe off dirt on the connector of the unit and faceplate. Use
a cotton swab or cloth.