13
compressor cannot shut off automatically. When the desired pressure is reached, turn the compressor button to off
manually.
1. Press pressure setting buttons ‘+’ or ‘-’ to check the pre-set pressure. When the gauge shows “Target”, then
the setting showing on the gauge is the pre-set pressure.
2. Adjust to your desired pressure by pressing the pressure setting buttons ‘+/-’.
3. Press button ‘+’ to increase the pressure and press button ‘-’ to decrease the pressure. Once the desired
pressure is reached, stop pressing the buttons. The display will return to 0 Bar automatically.
That means the pressure is preset successfully. The product is ready for inflating.
In the process of inflating, the pre-set pressure can not be adjusted.
Inflating Tires
2.5
UNIT
+
-
Fig 7
click
Fig 8
Fig 9
1. Insert the battery pack into the unit, and the LCD display will turn on (See Fig 7).
NOTE: If you do not use the unit about 50 seconds the digital will turn off automatically to conserve energy.
2. Adjust to your desired pressure (refer to Pressure Pre-Set).
3. To choose the desired pressure format (PSI, BAR, KPA, KG/CM2), press the "UNIT” button continuously
until the desired format displays (See Fig 8).
4. Screw the thread connection onto the tire's valve stem. Then put the trigger down (See Fig 9).
5. Press "+” or "-” to set desired pressure level. Once set, press the "UNIT” button to make sure.
NOTE: Always check and follow the manufacturer's recommended pressure, usually located on the door
jamb of your vehicle. In the process of inflating, the pre-set pressure cannot be adjusted.
6. Being sure the trigger lock is in unlock position, press the trigger.
7. The unit will begin to inflate the tire to the set pressure level, and shut off automatically when reaching.
NOTE: For long time operation you should press the trigger then put the trigger lock in lock position so that
you can release your hands.
7. When done, put the trigger lock in unlock position.
8. Remove the thread connection from the tire quickly, and replace the valve stem cap on the tire, if required.
WARNING:
The connector may be hot. Use caution when removing.
NOTE:
To avoid over-inflation of tires, please check the recommended tire pressure in the vehicle's manual. For
bicycle tires, check marking on tires.
WARNING!
Please read and understand the instructions provided in the manual prior to operation.
Always turn off the unit when not in use to conserve battery power. Use a separate gauge for more accurate
reading.