Norac UC5 Topcon X30, Руководство оператора

Страница: 9 / 68

7
Figure 1: NORAC UC5 Run Screen – Manual Mode Figure 2: NORAC UC5 Run Screen – Automatic Mode
The height displayed under the boom in the upper right corner is known as the target height. This is
measured from the spray nozzles to the soil (Soil Mode™) or to the crop canopy (Crop Mode™ or Hybrid
Mode™). The crop at the bottom of the screen indicates the mode the controller is in. If the green line is
above the crop, the system is in Crop Mode. If the green line is below the crop, the system is in Soil
Mode. If the green line is both above and below the crop, the system is in Hybrid Mode.
The following applies to Virtual Terminal only:
When two or more virtual terminals are connected on the display bus, the move to next VT button will
appear on the soft key area of the run screen. This button allows the user to select the preferred terminal
on which to display the UC5™ screen. By pressing this button the UC5 screen will move to next available
terminal.
AUTO
Button
MANUAL
Button
Settings
Button
Boom
Height
and
State