Norac UC4.5, Руководство оператора

Страница: 26 / 54

22
Calibrating the Sensor’s Height Reading (Zero Height):

Ensure the sprayer boom is unfolded and the sensors are located over bare soil or gravel.
Position the boom at a normal working height. Do not conduct this procedure over
standing crop or tall grass/weedy areas. It is recommended to perform this calibration in
soil mode.

Using a tape measure, measure the distance from the bottom of the spray nozzle to the
ground ( Figure 9 ). Use the spray nozzle closest to the sensor. Round this measurement
to the nearest half-inch.
Figure 9: Measurement for Calibrating the Sensor Height

Navigate to the location measured, for example, "LOht" for the left outer sensor ( Figure
8) .

If the currently displayed height reading is not correct, adjust it using the buttons.
The button will increase the reading; the button will decrease the reading.

To return to the Normal Operating Screen, press and hold the or button for two
seconds.
Note: To view the absolute height reading from the sensor to the ground, press and hold the button
from the “LOht” menu. This height reading can be useful for troubleshooting purposes.