Norac SPRA-COUPE 7000 Series, Руководство по установке, Страница: 15 / 42

13
Improved boom tip protection and control may be obtained by mounting the
sensor as close to the end of the boom as possible. However, if the sensors are
mounted to the breakaway portion of the boom, the operator must be
aware that, due to boom geometry, a breakaway action may cause the
UC4 Control Panel to force the boom dangerously close to the ground.
For this reason, you may want to avoid mounting on a breakaway
section.
Please refer to the UC4 system warranty at the end of the UC4 Sprayer Boom
Control Operator’s Manual ( Item M1 ) for implications.
NOTE: When installing the UC4 sensors (Item E2), start with the
smallest serial number on the left hand side proceeding to the
largest serial number on the right hand side (Figure 6). This
will allow for a more intuitive setup when tuning the system.
This arrangement is also REQUIRED when using the “QUICK
SETUP” feature available via the UC4 Control Panel software
(this feature is typically used by NORAC technical support
staff).
Figure 6 – Sensor Serial Number Installation Location
4. The sensor mounting brackets can be installed two basic ways. One with the
base behind the tube ( Figure 7 ), which is preferred, or with the base mounting
in front of the tube ( Figure 8 ). Both mountings are acceptable however the