7
NookBox
Installation Guide
Remote Keypad KP-35
Change of Battery
•
Put the Control Panel to programming menu to bypass the KP tamper alarm.
•
Dismount the Remote keypad.
•
Take out the old battery and press any key to discharge before replacing the new battery in the battery compartment,
with unmarked (negative) side of battery facing down.
•
Close the case using the rear fixing screws.
•
Screw back the Remote keypad to the surface with mounting screws.
•
Put the Control Panel back to normal operation mode.
Reset Remote Keypad to Factory Default
•
The Remote Keypad can be reset to clear all learnt-in data and return all setting to default value by following procedure below:
•
Please follow Change of Battery procedures for factory default.
•
Enter “0000” + “#” to reset Keypad to default value.
•
“Reset Default” will be displayed on the LCD screen along with 3 beeps indicating successful operation.
•
All learnt-in data will be cleared.
•
Entry/ Exit Beeps will be disabled.
•
Alarm Beep will be disabled.
•
Dual Key alarm function will be disabled.
NOTE:
•
Factory default setting can only be performed within 10 seconds after inserting batteries. If the Keypad is not wake up within 10 seconds
after inserting batteries. Remove batteries and try again.
•
Factory default does not affect ZigBee learning. The Keypad does not need to be relearnt again after factory default.
Mouting Remote Keypad
The Keypad is designed to be wall mounted with fixing screws and plugs provided.
The bottom of the Keypad has 4 knockouts, where the plastic is thinner, for mounting purpose.
1.
Break through the plastic knockouts on the base.
2. Drill 4 holes and fix the screws & plugs provided.
3. Screw the base onto the wall.
4. Reattach the base and cover assembly.
