5
NookBox
Installation Guide
IR 360 Detector
Battery
The Detector uses 1 CR123A lithium 3V battery
The batteries are included in the package. The Detector feature low battery detection function. A low battery signal will be sent to the Control
Panel along with regular signal transmissions for the Control Panel to display the status accordingly.
<NOTE>
When changing batteries, after removing the old batteries, press the Tamper Switch twice to fully discharge before inserting new batteries.
Tamper Switch
The Detector has a tamper switch located on the back of the Detector main body. When the Detector is properly installed on the back cover,
the tamper switch will be compressed. When the Detector is removed from the back cover, the tamper switch will be activated and trigger the
Detector to send a tamper open signal to the Control Panel.
Getting Started
• Insert the battery into the battery compartment.
• The LED indicator steadily flashes for 30 seconds. (The Detector is warming up). During the warming period, the Detector will not be
activated.
It is recommended that you stay away from the detection area during this time. After the warming period is over, the light will turn off
and the Detector will be ready for operation.
• Put the Control Panel into learning mode, refer to Control Panel manual for detail.
• Press the learn/test button on the front cover.
• If the Control Panel receives Detector signal, it will display the information accordingly, refer to Control Panel manual to complete the
learning process.
• After the Detector is learnt-in, put the Control Panel into “
Walk Test
” mode, hold the Detector in the desired location, and press the Test
button
to confirm this location is within signal range of the Control Panel.
• When you are satisfied that the Detector work in the chosen location, you can proceed with installation.
