Rainbow !Jed Assembly Instructions
Dave Cady's
NOMAD FURNITURE
Albuquerque, NM www.nomadfurniture.com 505-250-5231
Tools needed for assembly
A phillips screwdriver
Rubber mallet or hammer w/block included
Optional: one friend
Bed parts list
2 short legs with shoulder screws
2 Jong bed legs-headboard
2 Rainbow crosspieces (Cure)
2 crosspieces with small holes
I crosspiece without holes
2-side rails with ledges
Croscpie::
e
1-center support (2 for King size)
1 strapped slat roll
4-5/8"shoulder screws
2-1" screws(for slats)
Extra Footboard Option:
Add 1 more Wave Crosspiece With
longer legs
Go to page two for instructions Ro i
1
0--i I led Croscp
i
s:e �
. � .___I
_o-----------==....
i
, ,ed Croscp=-=:.::
ie::
:-::::..._____
e
__JI �
HeadboardAssembly
/
1.
If
possible, go to this site for photo slides of assembly
NOMADFURNITURE.COM/BED-ASSEMBLY-GALLERY/
2.
Identify all pieces before beginning. Lay out parts as shown in written instructions.
Note: To protect the wood only use a hammer
with
the wood block in
shipping box
as a
pad,
to tap down parts. Or a rubber mallet
works nicely with a baggie over the mallet (no black marks).
3.
Attach one of the drilled crosspiece to the bottom set of shoulder screws on one long leg and tap down snug.
Note: When connecting rails and crosspieces to legs, slotted ends should be pushed down over screws. Refer to our
"CAlITION SHEET" and use the alignment stick to assist with assembly.
4.
Attach undrilled crosspiece to the second set of shoulder screws on the same long leg and tap down snug.
5.
Choose and attach lower Rainbow crosspiece to third set of screws.
6.
Attach remaining Rainbow crosspiece to the highest set of screws.
7.
At this point all the crosspieces should be attached to one headboard leg.
8.
Grab the remaining long headboard leg and simultaneously attach all fuur crosspieces. Lay the headboard down and
use the ½" spacer alignment stick to connect crosspieces to leg. Tap down snug .
9.
Add lower crosspiece to the same leg and tap down snug.
10.
Attach all the crosspieces simultaneously to the other headboard leg using the½" spacer to help. Tap down snug.
Note: It is important that all joints are tapped down completely.
