Federal Communications Commission (FCC) Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
CAUTION:
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●
Consult the dealer or an experienced radio/TV technician for help.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
NOTE:
CAUTION
1. Risk of fire. This product does not contain lamp shunts, so if one lamp burns out, the lights in that
circuit will not light.
Caution
ADAPTOR MODEL NO. TS-4.5V1A
2. To reduce the risk of fire and electric shock: a) do not install on trees having needles, leaves or
branch coverings of metal or materials which look like metal, and b) do not mount or support strings
in a manner that can cut or damage wire insulation.
packaged with this product or marked for use with this product.
3. To reduce the likelihood of excessive heat and possible damage, use only decorative lamp accessories
Replace the lamp
User servicing instructions
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Unlock the burned-out LED lamp by lifting the hook.
4. Replace lamp with only 3.0 V, 0.072 watt push-in type LED lamp (provided with product).
5. Lock the hook of lamp base by pushing lock down into the tab.
3. Pull lamp and plastic base straight out of lampholder.
Always match the hook to the tab.
Caution
To reduce the risk of overheating, replace burned-out lamps promptly. Use 3.0 volt, 0.072 watt
LED lamps only.
CAUTION:
If the lamp base of the replacement lamp does not fit in the string: (as shown below by the Figs.)
a) Remove the base of burned-out lamp by straightening lamp leads and gently pull lamp out.
b) Thread leads of new lamp through holes in old base with one lead in each hole.
c) After lamp is fully inserted into base, bend each lead up, like other lamps in the light set
so that the leads will touch the contacts inside the lampholder (always match the long lead
of new lamp to the hook of lamp base).
Unlock
Lock
Hook
Tab
