6. Allow branches to fall into place or gently pull up and out. When adjusting branches, be sure that all wires are free of branch hinges.
7. Plug the adaptor into the wall outlet. (See Fig. B) Your entire tree should now be lit.
8. Begin to shape the branches and tips, working from the bottom to the top. Start with tips farthest from the pole and fan out one to the
right, one to the left and one at the centre of the main stem. (See Fig. C)
9. Once the shaping of the entire tree is completed, slightly upsweep all branch tips so a uniform look may be obtained. Shift branches to
fill any gaps. Your Christmas tree is now complete and ready to be decorated.
Top view
Side view
Fig. C
1. For pre-lit trees, first unplug adaptor from the wall outlet, remove all ornaments and decorations. Disconnect light cords between
each section of the tree.
2. Disassemble the tree from the top to the bottom. Start with the tree top: gently lift straight up to remove from section below, and
fold all branches toward the pole.
3. In case of difficulty separating the tree pole (trunk), apply a small amount of lubricant at the joint and gently twist the upper pole in
both directions. Lift up the upper pole again.
4. Continue by gently lifting straight up each section from the section below and folding all
branches toward the pole until the bottom section is removed from the tree stand. Put the
protective cap on the poles to avoid damaging the internal parts. (See Fig. D)
5. Carefully place all tree sections into shipping box and tape it shut.
6. When not in use, please store your tree in a cool, dry place away from sunlight. Exposing your
tree to excessive heat or humidity may damage your tree.
7. Dispose of used batteries per municipal or provincial law.
8. Battery must be recycled or disposed of properly. Dispose of as per the requirements of your local municipality.
9. Keep out of reach of pets and children.
STORAGE INSTRUCTIONS
Press the Selector Button to select from the 7 preset light effects in the following sequence:
1. Steady Glow 2. Slow Fading 3. Fast Fading 4. 3 Speeds Fading
5. Slow Blinking 6. Fast Blinking 7. 3 Speeds Blinking
OPERATING INSTRUCTIONS
You can customize the light functions by using either the Light Controller or the Remote Control.
1. Before using the Remote Control, remove the insulation tab on its rear.
2. Press the Selector Button once on either control and wait for a second to enjoy light effects in the pre-programmed sequence.
There are 5 brightness levels. Simply press the controller buttons to
increase or decrease the brightness to your liking.
Default Timer Function:
Lights stay ON for 8 hours and then turn OFF for 16 hours. Timer function will restart when
any control button is pressed or main power supply to the lights is reconnected.
Memory Function:
If you unplug and reconnect the product to the power outlet, the product will resume
the last light effect and brightness level that was selected before the power was cut out.
Insulation Tab
Remote Control
Light Controller
Selector
Button
Fig. D
