4 Channel receiver with self-learning,
it manages standard codes from 12 till 80
and rolling HCS© or rolling EB
RX2-LUCI
+ 12/24 Vac/dc
1
2
3
4
- 12/24 Vac/dc, - Antenna
BUS
P1
+ Antenna
P2
L1
L2
L3
5
6
7
8
9
10
N.O.
COM
OUTPUT 1
N.C.
N.O.
COM
OUTPUT 2
N.C.
POWER SUPPLY (1 and 2).
The receiver can be powered from 12 to 24 volt in AC and DC as well. The polarity must be
used in case of DC (positive on clip nr. 1).
ANTENNA (2 and 4).
The antenna must be connected with positive (the spirit) on the contact no.4 and negative (stocking).
If only one is used (17cm for freq. 433,92 Mhz), this has to be connected to contact n°4.
OUTPUT (from 5 to 10).
The normally opened rele´ of exit 1 is on contact n° 5 and 6 while the normally closed contact is
on contact n° 5 and 7. For output 2 the normally opened contact is present on clips n° 8 and 9 while the normally closed
contact is on contact n° 8 and 10.
It is recommended not to connect such contacts to high tension and to make sure that the
current not exceed 5 ampere.
CONNECTION OF THE RECEIVER
DIP 1 ON -> 12V
DIP 1 OFF -> 24V
PROGRAMM DIP
DIP 1
Power supply setting:
OFF if connected to a 24V power source - ON if connected to a 12V power source.
DIP 2
ON
EB Rolling
code function activated
DIP 3
ON
HCS rolling
code function activated
DIP 4
ON
Reduce the output activation from 0.8 to 0.3 s
DIP 5
ON
The receiver will accept only the same type of code of the fi rst memorized remote controls, the next
one should have the same type of code.
DIP 6
ON
If you are using the HCS rolling code function, DIP 3 in ON, keep pressed button 1 and 2 of the remote
control which has been already memorized, the codes learning is in the OUT1. If you are memorizing
EB rolling code, DIP 2 ON, you activate the self-memorization of the remote controls with the same
installation code.
DIP 7
ON
Excluding the step-by-step function on the time outputs.
DIP 8
ON
It activate the managing of the inverted code (diff erential Manchester encoding)
