Nolan N-Com, Инструкции по безопасности и эксплуатации, Страница: 6 / 19

23
ENGLISH
equipped with the battery will be the Pilot’s helmet, and it will also be the one fitted with the e-box.
- After positioning the Basic Kit inside the helmet, apply the adhesive sealing trim around the 10-way connector as follows:
• Remove the N-Com protection cover from the helmet (fig. 2)
• Remove the protective film from the gasket
• Apply the sealing trim around the 10-way connector as shown in figure 3 and 4
- Insert the e-box in its compartment (fig. 5). First insert the front part, then press down on the e-box until both fasteners
click (fig. 6). To remove the e-box, operate at the same time on both sliding hooks until the e-box is ejected (fig. 7).
Warning: Do not leave the helmet exposed to atmospheric agents without the e-box or the protection cover supplied with
the helmet.
FIG. 2 FIG. 3 FIG. 4
FIG. 5 FIG. 6 FIG. 7
NOLAN nCOM intercom 0025 10-07-2007 13:45 Pagina 23
22
ENGLISH
2. CONTENTS OF THE PACKAGING
The N-Com Intercom kit contains:
3. INSTALLATION
3.1. Operating diagram
The diagram below illustrates the possible connections of the N-Com Intercom kit system (Fig. 1)
3.2. System installation procedure
Warning:
In order to use the N-Com Intercom kit system, both Nolan N-Com helmets have to be equipped with the Basic Kit
(sold separately). Please refer to the specific instructions provided with the Basic Kit for proper assembly on the helmet.
Note:
Before using the N-Com Intercom kit system, the battery has to be charged, as explained in paragraph 8.3.
Pilot’s helmet
�
- Insert the battery in its compartment in the Basic Kit (see specific instructions provided with the Basic Kit.) The helmet
Nr 1
Intercom E-box Nr 1
Sealing trim Nr 1
Rechargeable battery Nr 1
Intercom Wire Nr 1
Battery charger
N-Com Intercom
FIG. 1
NOLAN nCOM intercom 0025 10-07-2007 13:45 Pagina 22
6