Nokoser TC-X, Инструкция по эксплуатации

Страница: 13 / 15

After putting multiple batteries, click the battery icon which one the users
want to check; the battery icon turns red, and all the information at the top of
the main interface is the information of the selected slot
.
As shown above
5) Change settings:
If users want to change the setting, there are two ways:
①
When putting the battery, waiting for 8 seconds, click the battery icon.
(Note: For Ni-MH batteries, charging current must be within 8 seconds. If
there is no operation within 8 seconds, then charge in the default current and
the current cannot be changed during charging.)
②
During the charging process, select the battery icon which need to change
settings and click the battery icon again to enter the setting interface.
BATTERY ACTIVATION
For every installed battery, the TC-X will activate the battery by charging it.
Activate automatically for Li-ion batteries with protection board, which are
instantaneous short circuit. For the unprotected batteries’ voltage is above 0.2V,
the activation methods are as follows:
A. Put the batteries in the TC-X. (During the process, it is normal that Li-ion
batteries will be detected as Ni-MH batteries.)