Nokia IP560 - Hard Disk Drive Based, Руководство по установке

Страница: 50 / 160

3
Performing the Initial Configuration
50 IP560 Security Platform Installation Guide
connections and still do not see either the BOOTMGR> or Hostname?
prompts, verify that the terminal or terminal emulator program settings
are correct. If the settings are correct, contact your Nokia service provider
as listed in
“Nokia Contact Information” on page 3.
2. Respond to the Hostname? prompt within 30 seconds to prevent the
DHCP client from starting.
If the DHCP client starts, it might configure the appliance with an
incorrect host name and IP address (this could happen if a DHCP server
on your network is configured to respond to any request). To reset the
incorrect host name and IP address:
a. Establish a console connection to the system.
b. Enter the following:
rm /config/active
or
mv /config/active /config/active.old
c. Reboot the appliance.
d. Respond to the Hostname? prompt within 30 seconds to prevent the
DHCP client from restarting.
3. At each subsequent prompt, enter the requested configuration
information.
For more information about how to respond to the prompts during the
initial configuration process, see the release notes for the Nokia software
release you are running.
4. To select an interface, enter the number adjacent to the physical ID in the
list of connected interfaces.
Note
A physical ID identifies the NIC type ( nic_type ) and provides
information about its slot number ( slot_num ) and port number
( port_num ). The physical ID syntax is: