Nokia IP1220 - Security Appliance, Руководство по установке

Страница: 50 / 128

4
Installing and Replacing Network Interface Cards and Accelerated Data Path (ADP) Services Modules
50 IP1220 and IP1260 Security Platforms Installation Guide
Removing, Installing, and Replacing NICs or the ADP
Module
The IP1200 Series has two slots on the front of the appliance that hold two 6U PMC carriers or a
single Accelerated Data Path (ADP) services module.
All NICs installed in the IP1200 Series are housed in the 6U PMC carrier. You must first remove
the 6U PMC carrier from its slot before you can remove or install a NIC.
ADP modules use a carrier similar to the 6U PMC carrier, but the device uses both slots 1 and 2
in your appliance.
Note
Because the IP1200 Series supports hot swapping of NICs, you do not have to turn off
power from the system to remove, install, or replace these devices. ADP modules, however,
are not hot-swappable.
Before You Begin
Before you install a NIC, make sure that the rubber gasket around the front of the NIC is
installed properly.
To remove, install, or replace a NIC or ADP module you need the following:
„
Phillips-head screwdriver
„
Suitable, grounded work surface on which to place the PMC carrier or ADP module
„
Replacement or new NIC or ADP module
To replace a network interface card (NIC) or ADP module
Note
If you are servicing the slot 1 carrier, Nokia recommends that you disconnect interface
cables from the PMC cards
after you remove the carrier, as it is more difficult to remove
cables from a carrier installed in that location.
1. Identify the location (PMC carrier and slot) of the NIC or ADP module to be replaced.
Note
For ADP modules, even though the device occupies slots 1 and 2, the location is
identified as slot 2 only.
2. Loosen the screws on each side of the PMC carrier or ADP module. The screws are located
behind the ejector and locking levers.
All manuals and user guides at all-guides.com