Nokia products
require
power injectors that support a 12.5K Ohm detection resistor and
provide a power output of 60W per port in a 4PPoE implementation.
Nokia recommended midspan devices are listed in the
Table 5
Nokia recommended midspan devices
Manufacturer
Model
Number of ports
Micro-semi
PD-9606G
6
Micro-semi
PD-9612G
12
Micro-semi
PD-9501GR
1
Phihong
POE480U-4UP
4
Phihong
POE480U-8UP
8
For more information and specifications, check the manufacturers' websites.
5.4 Installation options
This chapter describes Flexi Zone Indoor Pico BTS possible installation scenarios, which
are wall, pole and ceiling installations.
w
NOTICE:
Flexi Zone Indoor Pico BTS equipment must be installed by trained and
qualified service personnel in accordance with all local codes and requirements.
w
NOTICE:
Flexi Zone Indoor Pico BTS equipment is intended for installation in restricted
access location or equivalent.
w
NOTICE:
The unit may become hot and should be installed away from any potential
sources of moisture (away from heating or cooling ducts, doors/window). Ensure good
airflow for the unit to allow proper heat dissipation.
w
NOTICE:
The unit should be located away from any RF radiation sources, out of direct
sun exposure, and away from a potential salt spray.
w
NOTICE:
Avoid installing the device near windows to avoid external interference.
w
NOTICE:
When installing the mounting bracket onto a vertical pole or a wall ensure the
arrows point upwards.
For wall, pole and ceiling installation instructions refer to the
Flexi Zone Indoor Pico BTS
Quick Start Guide
.
The FZ Pico Indoor module can be installed in three possible ways.
Flexi Zone Indoor Pico wall installation
g
Use the mounting bracket to install the Flexi Zone Indoor Pico BTS onto a wall.
Construction
Flexi Zone Indoor Pico BTS Product Description
14
DN09210454
Issue: 01
