I n s t a l l a t i o n
12
• When installing the parts of the car kit, make sure none of them
interfere with or hinder the steering or braking systems or other
controls or systems used in the operation of the vehicle (for example,
airbags). Make sure the car kit and any of its components are not
installed where you might come in contact with it in the event of an
accident or collision.
• Your service technician or dealer may be able to provide you with
information on alternatives for mounting the equipment suitably in
your vehicle without requiring bore holes.
• Do not smoke when working on the car. Make sure there is no source
of fire or flame nearby.
• Take care not to cause damage to electrical cables, fuel or brake
lines, or safety equipment during installation work.
• Make sure cables are placed so that they will not be subject to
mechanical wear and tear (for example, not laid under car seats or
over sharp edges).
■
Insert the remote control battery
The wireless remote control is powered by one CR2032 lithium coin cell
battery. Replace the battery only with the same or equivalent type.
1. Slide the cover away from
the device (1).
2. Insert the battery with the
negative (-) terminal
pointing towards the circuit
board, and slide the cover
back into place (2).
Extreme temperatures reduce
the performance and lifetime of the battery. The remote control may not
work or
Remote control battery low
may be displayed temporarily in
temperatures well below freezing.
