6 - Installation
Installation
Opening the measurement module
Opening the module is necessary only for replacing the battery and for wiring
the internal connector on the ES model.
•
Detach the measurement module from the radio module.
•
Use a large flat-bladed screwdriver to push the measurement module
cover off via the rectangular hole (see picture).
•
Pull the circuit board out.
•
Assemble reversely, taking care that the circuit board sits on the
grooves.
Wiring
The wiring of the sensor connector is described in the chapter for each module, where applicable.
Configuring
Configure the device per page 7 and per the chapters for your modules.
Mounting
Select a good place for the transmitter, avoiding metal surfaces
near the radio module.
Fasten the radio module to a surface either with a double-sided
tape or with two screws 50 mm apart. The maximum diameter of
the screws is 4.5 mm.
Alternatively, use a mounting plate available separately.
If not already, join the two modules.
Using with Ovaport
The device sends the measurement data with its radio network address using the channels as
described in the measurement module chapters. A compatible gateway is needed.
