Nogueira SDN-170A, Инструкция по эксплуатации

Страница: 20 / 56

20
Instructions Manual
CUTTING BAR
DAILY VERIFICATION OF THE OIL LEVEL:
Place the machine on a flat surface, so that the bar is leveled in both directions. Use a level to verify the
leveling. If necessary, adjust the position of the bar when using wooded shims.
- Hot oil: Wait for about 5 minutes;
- Cold oil: Wait for about 15 minutes.
Remove oil plug A.
Place the dipstick at the same place as the bottom of the bar.
NOTE: The dipstick is supplied with the machine, fastened to the belt shielding cover (fig.24).
The oil level must be between the MIN and MAX markings on the dipstick (fig.26).
If the oil level is low, fill it with SAE-90 oil till the maximum level.
fig.22
fig.23
fig.24 fig.25
fig.26