How to set up the rotary tool stand
1
2
3
4
5
Your rotary tool stand comes disassembled in the kit, so locate both of
the pieces - the long metallic stick with a hook on one end (the stand),
and the plastic table-shaped block with a long screw in it (the table
clamp). You can see an image of the rotary tool stand in an assembled
form on page 15.
Adjust the screw on the table clamp enough to fit the clamp on the edge
of your table. Once you've hooked it onto the edge of your table, tighten
the screw so that the clamp is secure and does not move.
Take the stand and screw it into the table clamp as tight as you can.
Adjust the stand height as necessary by pulling the stand as long as you
need, and rotating to secure the position.
Now your stand is set-up! Hand your rotary tool on the metal hook on
top, and you're good to go.
How to attach the handle for precision work
1
2
3
Remove the thicker housing cap from the rotary tool.
You can see a picture
of the housing cap & its location on page 12.
Take the precision handle and put it on your rotary tool through the round
hole in the handle body.
To make it easier to identify the precision handle
in your kit, check the image on page 15.
Secure the precision handle by screwing the thinner of the housing caps
onto your rotary tool until tight.
Pro tip:
When working with the handle, hold the rotary tool like a pen between your
thumb and forefinger. It might need a bit of practice for perfect results.
36
Содержание NRT-128AC
Страница 2: ...1...
