NOCRY NIW-400NM, Инструкция по эксплуатации

Страница: 25 / 28

Wrench feels hot
Possible solution: It’s normal for the tool to get hot after extended use. However,
be sure to take regular breaks to
​
allow the wrench to cool down. Run the wrench
for approximately three minutes at maximum speed with no load and clean and
clear vents.
IMPACT WRENCH LIABILITY
This product is covered by an EU directive, valid since 01.01.1990, specifying that
the manufacturer is only liable for products if all the parts originate from the
manufacturer or are approved by them, and if the units are mounted and operated
properly.
If accessories or spare parts from third parties are used, liability can be partially or
completely inapplicable. So no using those shifty parts you picked up on the cheap.
In extreme cases the responsible authorities can prohibit the use of the entire unit.
We recommend you always buy original parts and accessories as compliance with
all safety regulations is guaranteed, meaning you are covered and protected.
Another weight off your mind.
RESPONSIBLE DISPOSAL
This product has been marked with a symbol relating to removing electric and
electronic waste.
The Waste Electrical & Electronic Equipment Regulations (WEEE) requires that any
product showing this marking must not be disposed of with other household or
commercial waste. To prevent possible harm to the environment or human health
24