OPERATION
8
Speed Scrub 2001HD (03--05)
MACHINE INSTALLATION
UNCRATING MACHINE
1. Carefully check the shipping crate for signs of
damage. Report damages at once to carrier.
2. Check the contents list. Contact distributor for
missing items.
Contents:
S
Pad Driver -- Optional
S
2--12 V Batteries -- Optional
S
Battery Charger -- Optional
S
Battery Tray (#601991)
S
38 cm Battery Cable (#130364)
S
1--FaST--PAK 365 Concentrate (#1017019)
(FaST Model)
S
Squeegee Assembly
Brushes and pads must be purchased separately.
3. To uncrate your machine, remove the shipping
hardware and straps that secure the machine to
the pallet. Position a ramp at the rear of the
machine and carefully back the machine off the
pallet.
ATTENTION: Do not roll machine off pallet unless
a ramp is used, machine damage may occur.
ATTENTION: To prevent possible machine
damage, install batteries after removing machine
from shipping pallet.
INSTALLING BATTERIES
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Hood Open When
Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
Battery Specifications:
Two 12 volt, deep cycle batteries. Consult with an
Authorized Distributor for specific batteries. Maximum
battery dimensions are 178mm (7 in.) W x 381mm
(15 in.) L x 356mm (14 in.) H.
1. Turn all switches to the OFF position.
2. Carefully hinge open recovery tank to access the
battery compartment. Remove loose battery
cables from the compartment (Figure 1).
FIG. 1
3. Carefully install batteries into battery tray at
bottom of compartment and arrange battery posts
as shown (Figure 2).
ATTENTION: Do not drop the batteries into the
compartment, battery and machine housing
damage may result.
(+)
(--)
(+)
(--)
FIG. 2
4. Before connecting the battery cables, make sure
the terminals and posts are clean. Use a post
cleaner and wire brush if necessary.
NOTE:
Apply a light coating of non-metallic grease or
protective spray on the cable connections to prevent
battery corrosion.
5. Connect battery cables to battery posts as shown
(RED TO POSITIVE & BLACK TO NEGATIVE)
(Figure 2).
6. Turn on the main switch and check battery meter
charge level to ensure batteries are fully charged.
Charge if necessary (See CHARGING
BATTERIES).
