REVERSE OSMOSIS SYSTEMS RO 4... /E /EL - INSTRUCTIONS MANUAL
s.r.l.Milano - ITALY
Page 12 of 25
ro4e_mi-r10.doc -
r. 10
5.2.2. How to set language
The programmer LOGO allows to select the language of menu and of messages :
- To set the language of menu, proceed as follows:
1. push the button
ESC
2. push the button
until the pointer
>
indicates "Set …"
3. push the button
OK
.
4. push the button
or
until the pointer
>
indicates "Menu language"
5. push the button
OK
.
6. push the button
or
until the pointer
>
indicates the language desired
7. push the button
OK
to confirm (save) the modifications
8. push
twice
the button
ESC
to go back to the visualization of service
The programmer is already factory set on “english”.
- Set the parameter “B100” on position “
ON
” to select the italian language of the
messages; set on position “
OFF
” to select english language of the messages (proceed as
described at chapter 5.2.6).
5.2.3. How to set current time and day
The programmer is equipped with internal clock, keeping exact time for 80 hours in case of
power failure. To set the current time and day, proceed as follows :
1. push the button
ESC
2. push the button
until the pointer
>
indicates "Set …"
3. push the button
OK
4. the pointer indicates “Clock..”, push the button
OK
5. the pointer indicates “Set Clock..”, push the button
OK
6. push the button
to point the day or the number to be modified
7. when the pointer blinks on the day or the number to be modified, push the button
or
until the new desired day or value is shown (symbols related to days of week are
explained at following chapter)
8. repeat the same operation with other values, if required
9. push the button
OK
to confirm (save) the modifications
10.push
twice
the button
ESC
to go back to the visualization of service.
The programmer is already factory set for automatic updating with european summer time
(S/W Time ON = EU)
5.2.4. How to set times and delays
Proceed as follows, to make any modification :
1. push the button
ESC
2. push the button
until the pointer > indicates "Set param"
3. push the button
OK
4. push several times the button
until the parameter to be modified is visualized (B1 or
other)
5. push the button
OK
6. push the button
to point the number to be modified
7. when the pointer blinks on the day or the number to be modified, push the button
until the new value is shown
8. repeat the same operation with other values, if required
