3
3. Install Optical Drive Bracket back to the case
4. Put the bracket in the slot hole that will hold it in 110 degree angle, connect cables and the
power cords for the hard drive and optical drive
5. Lock the bracket
6. Connect power supply cords
Step 4: Connect Cables
Following your motherboard user guide to:
Connect Card Reader & USB Ports
z
There are two 10 pins USB connectors. One for the card reader
and USB, the other for the other two USB ports
z
Match the pin label (on connector) and your board user guide
USB port layout for accuracy.
Connect IEEE 1394 Port
z
There is one 10 pins 1394 connector
z
Match the pin label (on connector) and your board user guide
1394 port layout for accuracy. (Not all board has onboard 1394
port, leave It unplug if you don’t have it)
Connect HD Audio and e SATA Port
z
There is one SATA connector, connect it to your onboard SATA
port
Check your board to see if it has HD onboard port that supports HD
audio
z
If yes, plug the HD connector to your HD onboard audio port
z
If no, plug it to your AC 97 chipset onboard audio port using the
Y tale connector
z
Connect Power Switch connector to your onboard port
z
Connect Reset Switch connector to your onboard port
z
Connect HDD Power Switch connector to your onboard port
LCD Module
If you purchase the LCD programmable module. Simply take off the black label that blocks the LCD
window, install it behind the panel. No need to take off the panel, just take out the Optical bracket, you can
install the module directly inside the case.
Organize the cables with provided cable ties.
See picture for reference.
