NKT Photonics Koheras ADJUSTIK HP, Руководство по эксплуатации продукта

Страница: 64 / 115

Enabling and disabling emission
64
Enable emission
(front panel)
To turn on the laser using the front panel controls follow the steps in
Procedure 3
.
Note: The laser is equipped with internal temperature sensors that monitor the
temperature of sensitive components. If these components are outside their
specified temperature range, the laser source will halt emissions.
5 Observe that the status panel is shown with
indicators in the emission enabled state.
6 a. Set the reference wavelength offset for the
module using the slider in the Wavelength
offset control. To adjust the wavelength,
click-hold the slider to change its position.
b. Alternatively, enter the wavelength in
nanometer units by typing the value into
the offset input box at the upper right
corner.
c. For a laser with power control, set the
emitted power level using the slider in the
Power control . To change the power, click-
hold the red slider to change its position.
d. Alternatively, enter the power level in dBm
or mW units by typing the value into the
power input box at the upper right corner.
7 To disable emission – click the Emission ON/
OFF button once.
Action
Status indicators lit
GREEN and Emission
Enabled lit RED
λ
input field
P slider P input field
λ
slider
Click Emission
to turn OFF the
laser