NKT Photonics Koheras ADJUSTIK HP, Руководство по эксплуатации продукта

Страница: 63 / 115

63
Enabling and disabling emission
Procedure 3 Turning on the laser using CONTROL
Action
1 Connect to the laser using the procedures in Communicating with the Laser on page 57 .
2 If the indicator for Interlock in the status panel
is RED and Status is AMBER, check the
following:
a. The door interlock circuit is open –
Connecting the safety interlock on page 91
b. The external bus is not looped back with a
bus defeater – Connecting the safety
interlock on page 91
c. An interlock alarm requires manual
acknowledgment – Acknowledging
interlock alarms on page 92 .
d. The key switch is set to OFF – proceed to
step 2.
3 Turn the key switch on the front panel to the
ON position.
NOTE : If the key switch is set ON and the
interlock LED on the front panel is still amber,
turn the key back to OFF and then ON again.
This resets the interlock as long as the
interlock circuit is closed.
NOTE : If the interlock LED on the front panel
remains RED, even if the interlock circuit is
closed, pressing the Emission button will clear
the interlock when Emission is enabled. (See
the next step: 4.)
4 To enable emission, click the Emission button
once.
The emission indicator (next to the Emission
button) turns RED
The Status indicator turns:
•
GREEN – the laser is operating normally
•
Flashing GREEN – the laser has not reached
operating temperature (warming up)
•
RED – a system ERROR or interlock circuit
opened with emission enabled. (Emission is
disabled.)
Interlock Indicator
RED and Status
AMBER
ON
OFF
Interlock
Indicator
GREEN
Click
Emission
(ON)