NKT Photonics Koheras ADJUSTIK HP, Руководство по эксплуатации продукта

Страница: 61 / 115

61
5 Turning ON the Laser
Safety
Before you turn ON the laser, ensure that you are completely familiar and follow
all safety information and recommendations stated within this document and the
document:
Koheras ADJUSTIK Safety, Handling and Regulatory Information
– or –
Koheras ADJUSTIK HP Safety, Handling and Regulatory Information
You must follow all safety regulations required at the location where the laser will
be operated.
Preparation
The laser is ready to be turned on when the following steps are completed.
1. The laser is securely installed and connected according to the procedures in
“Mechanical Installation” on page 87
and
“Connecting the Laser” on page 91
.
This means the laser should be installed in the recommended environment
with power applied and at the very minimum the door switch interlock.
2. The laser is connected to a PC through either a USB or Ethernet connection
and the PC has CONTROL installed on it and executing according to the
procedures in
“Communicating with the Laser” on page 57
.
3. The FC/APC connector is placed so that any emissions are contained within
the working application such as a beam dump that can safely absorb the
emitted beam power.
Warning: Turning on the laser will emit hazardous laser Class 3B or Class 4 radia -
tion. Ensure to observe and implement all safety regulations, warnings and cau -
tions in this guide and the Koheras ADJUSTIK Safety, Handling and Regulatory
Information document before continuing.
Warning: Ensure the fiber connector face (tip) is clean. Optical power transmitted
through the connector may burn particles on the connector face damaging it. See
“Connecting the optical output” on page 95
.
Note: When connecting the output fiber patch cord, ensure to match it with an
appropriate fiber type.