NKT Photonics Koheras ACOUSTIK, Руководство по эксплуатации продукта

Страница: 48 / 96

Enabling emission from all modules
48
Warning: Ensure all fiber connector facets (tips) are clean. Optical power transmit-
ted through a connector may burn particles on the connector face damaging it.
Note: When connecting an output fiber patch cord, ensure to match it with an ap-
propriate fiber type.
Caution: Do not enable emission from the ACOUSTIK if any modules within it
have been exposed to temperature and humidity beyond the operating specifica-
tions. The Koheras lasers are designed to operate in a non-condensing environ-
ment from +15°C to +60°C. Before enabling emission, allow the modules at least
30 minutes to stabilized at the operating room temperature. Turning on lasers that
are too cold or hot may lead to damage.
Enabling emission from all modules
To enable emission from all modules inserted in an ACOUSTIK system, follow the
steps in
Procedure 4 .
Note: The modules are equipped with internal temperature sensors that monitor
the temperature of sensitive components. If these components are outside their
specified temperature range, emission is disabled.
Procedure 4 Enabling emission from all inserted modules
Action
1 Connect to the ACOUSTIK system using the procedures in Communicating with the
ACOUSTIK .
2 Select the system by clicking on its icon in the
Device selector of CONTROL – see
“Navigation” on page 59. .
When the system is selected, the control and
status panels display summary indicators and
controls for all inserted modules.
Status panel of the
the ACOUSTIK
Control panel
ACOUSTIK system
Click the
system
displays the
icon
selected
system