5
67_Pad_Pilot_UM_UK_11
3 SETTINGS OF THE PAD PILOT
3.1 Set up an address for the Pad Pilot
When the Pad Pilot is powered for the first time, the default address is 0, the LED
flashes once per second, waiting for the operational node address. Press
to
allocate an address.
If the Pad Pilot already has an address, there are two possibilities:
•
You wish to allocate a new address:
Press
+
simultaneously until you hear an audible signal (3
seconds) and the LED flashes once per second. You’ve accessed the setup
mode. To allocate a new address, press
.
•
You wish to set reset the default address (0):
To do this, press
+
simultaneously during 3 seconds, until you
hear an audible signal and the LED flashes once per second. The address 0 is
allocated to the Pad Pilot by pressing
. This restores the setup as it
was when the device was powered for the first time.
3.2 Key sound
Every time you press on a key on Pad Pilot, this generates a sound. This sound can
be disabled by entering the setup mode with
+
during 3 seconds until
you hear a Beep and then press the right arrow of
. Repeat the procedure to
activate the key sound.
