-
12
-
33-60-034-001_INST_GB_ radio receiver
5.2 About the pairing
Caution before you continue !
You must disable the MOB function on the remote radio devices before entering the pairing
procedure because the transmission of MOB messages to the receiver can disrupt the pairings.
For the Gyropilot Remote you must press on the STOP key of the transmitter until the signal
light stays on. When you release the STOP key the light will go out and the MOB is disabled.
For the Multifunction Remote you must press on the
◄►
key until the signal light stays on.
When you release the
◄►
key the light will go out and the MOB is disabled.
With the Crew MOB Transmitter, if the light is blinking you must press the ON button until the
signal light stays on. When you release the ON button the light will go out and the MOB is
disabled. If the light is blinking the unit is activated.
5.3 Initialization of the radio receiver
Press the init button until the red light signal stays on, release the button and the receiver will
start to beep at 1 second intervals.
You now have one minute to start the pairing procedure, at completion of each pairing cycle the
receiver will continue to beep for one minute to allow you to pair the next unit.
5.4 Pairing the Gyropilot transmitter with the receiver
1- Hold down the STOP key for three beeps, release the STOP key
2- Press and release the STOP key once
3- Hold down the STOP key for approximately three beeps, you will hear a long beep if the
pairing is successful. You will hear three short beeps if there is a problem with the pairing
and you must attempt the pairing again.
To exit the pairing procedure
The pairing procedure will automatically end one minute after the last device is paired or you
may press the init button to end the procedure at any time.
Important :
−
All Gyropilot, Multifunction and Crew MOB devices used with an individual radio Receiver
must be paired at the same time. The pairing of any single device subsequent to the
initial pairings will delete older pairings and they must all be redone.
−
The maximum number of devices for a radio receiver to be paired is 8.
−
Once you enter the initialization procedure you will need to have all your devices at hand
to complete the process.
−
Below the procedures for pairing the Gyropilot, Multifunction and Crew MOB devices are
detailed.