www.nkrowing.com.au
7
LAY OUT THE PARTS OF YOUR SYSTEM
Uncoil the wiring harness and lay it out in the shell. If you are installing your COX Vox in a sectional
shell, the harness should be equipped with a plug/receptacle pair which should be within a foot of
the sectional bulkheads.
INSTALLING YOUR SYSTEM
PLEASE, read through ALL of the installation instructions
before beginning to install your system!
Check that you received everything required. If you purchased a complete CoxVox system you
should have received the following items:
Carrying
bag
.......................................................................................................(1)
CoxVox control unit .........................................................................................(1)
microphone.........................................................................................................(1)
charger
..................................................................................................................(1)
speakers ............................................................................... (as ordered 2 or 3)
mounting
cup
....................................................................................................(1)
harness
..................................................................................................................(1)
“Do’s & Don’ts” card ..........................................................................................(1)
hardware pack with magnet ........................................................................(1)
NOTE: The double-sided “VHB” tape provided for mounting is epoxy based and requires 12 hours of
cure time. Do not get this tape wet while curing for best results.
INSTALL THE LOUDSPEAKERS
The NK loudspeakers are factory assembled and waterproofed using silicone-based protective
coatings. Rain, fresh water, and salt water should not harm the speakers, but we strongly
recommend that you install and angle the speakers so that any water which gets in can run out
again. The plug-in feature of NK speakers makes replacement very easy.
1.
Install the speakers using #6 x 1/2” panhead screws and the metal bracket (attached
to the speaker). We have supplied SIX screws; you will not use all of them unless you
are installing a three speaker system. Remember, it is best if the speakers are angled
downward to let water run out.
2.
Connect the speakers to the wiring harness. Use the remaining six cable clips to secure
the wiring harness. We suggest you use the #6 x ½” brass screws supplied to fully secure
these clips.
INSTALL THE MOUNTING CUP
Decide where you want to secure the cup and mark off the surface using the cup as a template.
Drill two pilot holes for the #8 x ½” panhead screws and secure the cup. Do NOT over tighten the
screws!
