Njoy Eido 600, Руководство пользователя

Страница: 4 / 21

06 07
Important Safety Warnings 4
Place the UPS indoors in an area that has adequate
airflow and no excessive dust. Do NOT allow the
UPS to be exposed to moisture, rain, excessive
heat or direct sunlight.
The use of the UPS is NOT recommended in
life support applications where failure of this
equipment can reasonably be expected or when
its safety or effectiveness could be affected
significally.
Do not plug the UPS input into its own output.
Please always disconnect the input power cord
from the wall outlet before replacing the battery.
Do NOT dispose of the battery in a fire. The
battery may explode.
Do NOT open or damage the battery. It contains
an electrolyte that is toxic and harmful to the skin
and eyes.
Proper disposal of the battery is required. Please
follow your local laws/regulations regarding
battery disposals.
Use tools with insulated handles to replace the
battery to avoid personal injury. Due to energy
hazard, please remove wrist watches and hand
jewerly when replacing the battery.
Problem Possible Cause Solutions
No LED display on
the front panel.
Low battery.
Charge the UPS at least
8 hours.
Battery fault.
Replace the battery with
the same type of battery.
The UPS is not
turned on.
Press the power switch
again to turn on the UPS.
Alarm continuously
sounds when the
mains is normal.
The UPS is
overload.
Remove some loads first.
Before reconnecting
equipment, please verify
that the load matches the
UPS capability specified in
the specs.
UPS fault
Return the unit to the
service center.
Alarm sounds every
2 seconds when the
mains is normal.
Battery defect.
Replace the battery with
the same type of battery.
Charging board is
damaged.
Return the unit to the
service center
When power fails,
back-up time is
shorten.
The UPS is
overload.
Remove some critical load.
Battery voltage is
too low.
Charge the UPS at least 8
hours.
Battery defect. It
might be due to
high temperature
operation
environment, or
improper operation
to battery.
Replace the battery with
the same type of battery.
The mains is
normal
but LED is flashing.
Power cord is
loose.
Reconnect the power cord
properly.
Troubles and solutions 5
Engli
sh
Română
Srpski
Deutsch
български