This appliance shall only be used with a butane gas cartridge certified to EN417 or UL147B
IT MAY BE HAZARDOUS TO ATTEMPT TO FIT OTHER TYPE OF GAS CONTAINERS.
*REMOVE ANY TRANSIT PROTECTION MATERIAL.
4
2
3
6
5
8
9
1.Make sure the control knob is turned all the way clockwise to the “OFF”
position. (Fig.1)
2.Open the gas cartridge compartment and slightly push the gas canister
inside by align slot of the gas cartridge with the valve tab.(Fig.2)
DO NOT use this appliance if it has damaged or worn seals.
DO NOT use this appliance if it is leaking, damaged or dose not operate properly.
3.Turn on the knob to “ON”positon.(Fig.3)
NOTE: if there is a leak from your appliance(smell of gas ) and you can not
stop the gas flow, remove the appliance to a well-ventilated location away
from any ignitions source. Check for leaks using soapy water.
Do not try to detect leaks using a flame.
CAUTION:when connecting or disconnecting the gas cartridge, be sure that
no external sources of ignition are present.
5.HOW TO REMOVE THE GAS CARTRIDGE
Turn the knob to the “off” position to extinguish the fire.
Remove the gas cartridge by lift up the bottom of the gas bottle, and take it out carefully.
4.HOW TO REPLACE A NEW GAS CATRIDGE
Check that burners are extinguished before disconnecting the gas cartridge. Be careful the gas cartridge may be hot.
Check the seals before connecting a new gas cartridge to the appliance.
Repeat above steps from 1-3.
WARNING
THE OPENINGS AT THE BASE OF THE BURNER PROVIDE AIR FOR COMBUSTION, THEY
SHOULD NEVER BE OBSTRUCTED. IF THE FLAME BECOMES SIGNIFICANTLY ORANGE CHECK
THESE OPENINGS FOR A BLOCKAGE.
IF THE APPLIANCE CAN NOT BE ADJUSTED TO PERFORM CORRECTLY IT SHOULD NOT BE
USED UNTIL SERVICED OR REPAIRED.
2. FITTING THE GAS CTRTRIDGE
1. NAME OF SPARE PARTS
5-2
1
1. Flat pan
2. Fluid tray
3. Pan supporters
4. Gas can side cover
5. Overpressure safety device
6. Switch knob
7. Heat dissipation hole
8. U shape burner
(Fig.1)
(Fig.3)
(Fig.2)
SLOT
VALVE TAB
