Using the Buttons
The buttons are labelled with SET,
▼
(down), and
▲
(up)
.
When your clock is showing
the time, you can briefly press
▲
to show the date and then the temperature. Also on
the time screen, briefly pressing
▼
will cycle through the LED backlighting colours.
If in a settings mode and no button has been pressed for 30 seconds, the display will revert
back to the normal time screen without saving.
Setting the Time
Press the SET button briefly and the display will be changed to only show the hour digits.
Press the
▲
and
▼
buttons to set the hour and SET to advance to the minutes to do the
same. After adjusting the minutes, pressing SET again will save the new time and return
to the normal time screen.
Using the Counter/Timer
When your clock is showing the time, hold
▲
for 3 seconds to start an up-counter. To start
a countdown timer, hold the
▼
button on the time screen, and the display will change to
showing just the timer hours. Press the
▲
and
▼
buttons to set the hours, then press SET
to advance to the minutes, and then SET again to start the timer.
When a counter/timer is running, briefly press SET to pause/resume, or hold SET to cancel.
Every minute the current time will be shown for about 3 seconds.
Changing your Settings
Hold the SET button for 3 seconds and the display will enter the settings menu. The
leftmost digit shows the setting number, and the rightmost digits show the current value
–
use the
▲
and
▼
buttons to adjust. Press the SET button briefly to advance to the next
setting, and at the end of the settings list it will save all changes and return back to the
normal time screen. The ordering and description of these options are shown below.
Setting
Number
Description
Usage
1
Set day-time display
brightness
Use
▲
and
▼
to set display brightness from 0
(min) to 7 (max).
2
night-time dispaly
brightness
3
Set night-time light
threshold
Press
▲
to use the current ambient light level
as the night-time detection threshold.
Press
▼
to use existing threshold.
“1” = New night
-time threshold will be set
“0” = No change to threshold level
