Nivus NivuSonic Clamp On, Инструкция по эксплуатации

Страница: 34 / 110

® Instruction manual
NivuSonic Clamp on
6.6.2 Communication Options
The following different options are available for communication with the NivuSo-
nic CO:
-
Direct Ethernet connection between PC/Laptop and NivuSonic CO using a
cross-link cable.
-
Ethernet level connection via TCP/IP, network connection via Ethernet hub
or switch. It is required to use patch cables.
-
Connection via network server using DHCP (Dynamic Host Configuration
Protocol) and/or DNS (Domain Name Server).
See a diagram depicted in Fig. 6-20 .
-
Internet connection via access portal (see Fig. 6-21)
It is required to use a NivuSonic CO equipped with according hardware such
as analog modem, ISDN modem or GPRS to set up such a connection.
The setup is described in Chapter 6.6.3.
-
Connection to SCADA systems via Modbus TCP (Ethernet)
-
Data or alarm transmission vie e-mail or FTP server
Fig. 6-19 Communication without Server
Fig. 6-20 Communication with Server
Page 34