4
INSTRUCTIONS FOR
THIS TOOL
About Your Tool
WARNING
●
Inspect an attachment for chips or cracks prior
to mounting.
Do not use an attachment that is chipped or cracked
or otherwise damaged.
●
Make Certain the diameter of the attachment
mandrel suits the chuck.
Fasten the attachment securely.
●
Wear protective glasses and a dustproof mask
Operation generates chips and dust particles, etc.
which may cause eye and/or respiratory injury:
Always use PPE (Personal Protective Equipment)
for eye and respiratory protection.
●
When you replace or adjust the cutting tool or
parts, be sure to disconnect the air hose from
the tool.
●
Never touch the moving parts while in operation.
CAUTION
●
Use NITTO genuine parts files and pads.
●
Use of the ones other than NITTO genuine parts
may cause abnormal vibration or defective
finishing surface.
●
The weight of the accessory for this tool should
be 12
〜
28g.
●
This tool is for filing workpieces using the
exclusive file. Do not poke workpieces with the
tip of the file, or it can result in failure.
●
When the user installs an additional air control
valve available in the market in the middle of air
supply line, while keeping the valve ring of the
tool to "on" position, and controls on/off with
the air control valve, use air hose of less than
11mm I.D. and in less than 1.5m in length from
the tool to the valve. Failure to follow the above
instruction may cause malfunction.
1. USAGE
This tool is for filing the workpieces using the
exclusive file.
2. CHECK THE CONTENTS OF THE PACKAGE
Check the contents and make sure that the tool
does not have any damage which may have
occurred during transportation. The contents should
correspond to the list as follows. In case of damage/
missing parts, please contact the sales agent from
whom you purchased the tool.
Package Contents
Qty Check
SUPER HAND ASH-900
1set
Rat Tail File SF-10
1
Triangular Taper File SF-11
1
Half Round File
( Rat Tail / Double Cut ) SF-12
1
Flat Bastard File SF-13
1
Hex. Socket Screw Key 2.5
1
Bushing R1/4x NPT1/4
1
Instruction Manual
1
Declaration of Conformity
1
Caution for Use
1
3. AIR SUPPLY
3-1. Air Pressure
Adjust air pressure with the air regulator to the
appropriate level for the pneumatic tool used.
Air pressure that is too low will stop the tool from
operating at full capacity.
Air pressure that is too high may cause damage to
the tool.
3-2. Air Line
(Fig.1)
Use a 9.5 mm (3/8") I.D. connecting hose between
the compressor and the tool. Drained water, etc., if
flown into the tool, could cause tool failure. Install an
air filter between the compressor and the tool.
Fig.1
I.D.
Fig. 1
3-3. Lubrication
Install an oiler between the compressor and the tool.
Use the machine oil ISO VG-10. Failure to lubricate
as required may result in damage to the tool. Use of
oil that is too thick will reduce the performance of the
tool.
ASH-900_E.indd 4
13.6.3 3:51:49 PM
