Nitto Kohki MG-40, Инструкция по эксплуатации

Страница: 8 / 24

6
(1
Repetitive Motion Hazards
WARNING
z
When using this tool to perform work-related activities, the operator may experience discomfort in the hands,
arms, shoulders, neck or other parts of the body.
z
While using this tool, the operator should work in a comfortable posture while maintaining secure footing and
avoiding awkward or off-balance postures. The operator should change posture during extended tasks; this
can help avoid discomfort and fatigue.
z
If the operator experiences symptoms such as persistent or recurring discomfort, pain, throbbing, aching,
tingling, numbness, burning sensations or stiffness, these warning signs should not be ignored. The operator
should tell their employer and consult a qualified health professional.
Accessory Hazards
WARNING
z
Disconnect the tool from the energy supply before fitting or changing the inserted tools or accessories.
z
Use only accessories and consumables that are the sizes and types recommended by the manufacturer of this
tool; do not use accessories or consumables of other types or sizes.
z
Ensure that the dimensions of the abrasive product are compatible with this tool and that the abrasive product
fits the spindle.
z
Ensure that the thread type and size of the abrasive product exactly match the thread type and size of the
spindle.
z
Inspect the abrasive product before use. Do not use abrasive products which could (possibly) have been
dropped or which are chipped, cracked or otherwise defective.
z
Ensure that the abrasive product is correctly mounted and tightened before use and run this tool at no-load
speed for at least 1 minute in a safe position; stop immediately if considerable vibration or other defects are
detected and determine the cause of these defects.
z
Prevent the spindle end from touching the bottom of the hole of cups, cones or plugs with threaded holes
intended to be mounted on machine spindles, by checking their dimensions and other relevant data.
z
Where abrasive products are supplied or used with reducing adaptors or bushings, the user shall ensure that
the adaptor or bushing does not contact the face of the flange and that the clamping force provides sufficient
rotational driving action to prevent the abrasive product from slipping.
z
In cases where flanges are supplied for several types or sizes of abrasive, always fit the correct flanges for the
abrasive being used.
z
Avoid direct contact with the inserted tool during and after use, as it can be hot or sharp.
z
Store and handle the abrasive product with care in accordance with the manufacturer’s instructions.
Workplace Hazards
WARNING
z
Slips, trips and falls are major causes of workplace injury. Be aware of slippery surfaces caused by the use of
the tool and also of trip hazards caused by the air line or hydraulic hose.
z
Proceed with care in unfamiliar surroundings. There can be hidden hazards, such as electricity or other utility
lines.
z
This tool is not intended for use in potentially explosive atmospheres and is not insulated against contact with
electric power.
z
Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the use of
the tool.
Precautions on Use