Nitto Kohki LO-3550, Инструкция по эксплуатации

Страница: 16 / 26

15
Fig. 23
(2) Make sure to clean the both portions of surface
of the work piece where the magnet is placed and
the hole is cut.
WARNING
Always keep the magnet sole clean. Always
keep the work piece surface clean. Any foreign
object between the magnet and the work piece
will reduce magnetic power. This could cause
the machine to move around during operation,
which may result in an accident. Keep all working
surfaces clean and
fl at without any rust, chips or
undulations.
(3) Align with Punch Mark
WARNING
Make sure that the lock screw to fi x body position
is securely fastened before drilling.
Loosen the lock screw on the side of the body, and
moves the body back and forth or around to align
the tip of the pilot pin with the punch. Then tighten
the lock screw in the arrow direction. (Fig. 24) The
lock screw has the wings and is designed to fasten
with hands. Do not tighten it with a spanner or the
like.
※
The lock screw can be mounted on either left or
right side of the body.
Lock Screw
Fig. 24
(4) Magnet ON
WARNING
Check to see that magnetic power is activated.
Turn on the power switch. Magnet will stick to the
work piece. (Fig. 25)
ON OFF
LOAD
Stop switch
OVER LOAD
OFF
OFF
ON
ON
MAGNET
Power switch
Start switch
Fig. 25
(5) How to attach the Guard
Please attach the guard as shown in Fig.26.
Guard
Fig. 26
(6) Drill Motor ON
WARNING
Do not touch any rotating parts.
Press the start switch to activate the drill motor.
(Fig. 27)
(7) Drilling
(7-1) Drilling
Turn the Feed Handle downward to start drilling.
For the
fi rst 2 – 3 mm of the drilling, slowly feed
the drill motor. (Fig. 27)
Feed slowly to 2 – 3 mm deep.
Feed slowly to
2 – 3 mm deep
Fig. 27