Nitta PP1535-1, Руководство по эксплуатации

Страница: 11 / 20

- 10 -
7.Operation Procedure
7-1) Pre-heat
Connect the main plug correctly to the socket outlet.
Power is supplied to the temperature controller and the current temperature of the
press is indicated on the temperature controller.
It takes about 30 minutes to preheat.
Now it is possible to confirm and change the set temperature.
Be sure to connect an earth line to prevent electric shock.
7-2) Temperature setting (Temperature controller)
1) Make sure that the power is applied to the temperature controller.
2) Push the para display change button three times to indicate “SP-1” on the present
temperature display.
At this time, the preset temperature display indicates the preset temperature.
※ The preset temperature before shipping is 110

C.
3) Push the (up) button to raise the preset temperature or push the (down) button
to lower. Push the button once and the flickering figure increase or decrease 1

C
each time.
Pushing the (side) button shifts the figure of temperature.
4) The figure of the preset temperature display is flickering when the figure of the
temperature is adjusting.
The preset temperature will be fixed when no pushing is made for 2 sec or more.
5) Push the para display change button two times to return the present temperature
display to the original state.
7-3) Discontinuing operation of the Heat Press while in use.
Disconnect the plug if it becomes necessary to discontinue operation of the Heat press
while it is in use.
Even if the plug is disconnected during operation, preset data of preset
temperature and hold time are maintained.
When operation is discontinued during use, the Heat Press is kept at
high temperature.
Be sure to wear heat-resistant gloves when handling the Heat Press.
Failure to do this may cause burns.
The operator should take measures to prevent other people from
touching the machine accidentally, until the Heat Press temperature
lowers to near room temperature (about two hours).
Failure to do this may cause burns to others.
If Heat Press operation is discontinued during the process of splicing a
belt, do not use the belt.
The splice may become defective, reducing the function and performance of
the belt, or rendering it unusable.
WARNING
WARNING
WARNING
CAUTION