Nitta FP70-10-100, Руководство по эксплуатации

Страница: 11 / 16

- 10 -
9-3-1) How to change the position of the cutting sheet - Continued-
③
Change the position of the cutting sheet by
sliding it forward or back in the hole on the
cutting sheet.
※
At the time of shipping, the cutting sheet is
set in the center of the hole on the cutting
sheet.
※
The picture at left shows an example of
sliding the cutting sheet forward in the hole.
※
Both sides of the cutting sheet can be used
and it can be set in any of the three positions;
forward, center and back.
※
④
Securely tighten the four loosened truss screws.
※
Fit the corner of the cutting sheet with the
corner of the belt guide.
9-3-2) How to reverse the cutting sheet
① Loosen the wing nuts, and the wing nuts, the
clamping bar, and springs are detached.
※ Be careful not to lose them taken out of the
finger puncher.
② The truss screw which is the fixation of the
cutting seat is detached.