Nitta FP-120G-60, Руководство оператора

Страница: 8 / 20

- 7 -
7. How to Make a Finger Joint
7-1) Required Tools (tools prepared in advance)
a. Finger Puncher
b. Tape Measure or Ruler
(for measurement of belt length)
c. Ballpoint Pen or Felt Pen (for marking)
d. Hexagon Wrench
7-2) How to Measure Belt Length
Measure belt length and mark on the belt.
1) Measure Length from cut end.
2) Measure length from finger end
(For continuous measuring)
(1)
Make the first mark 160mm from the
edge of the belt. (See diagram to left.)
(2)
Based on the first mark, make a
second mark at the ending point.
(Put both marks on the front side, i.e.
on the operator side.)
(3)
When consecutively making endless
belts, obtain required belt length and,
from the second mark made at the
preceding finger joint, measure out the
required belt length and make another
mark. Repeat the above process. By
doing this, punching can always be
done at the right position and there will
be no wasted belt.
Markings
Required length
Belt end
Markings
40mm
160mm
Clamping part
40mm
Required length
ａ
ｂ
．
c
d