NITEVIZOR OWL-XTR, Руководство пользователя

Страница: 4 / 18

4
OWL-XTR
Initial Setup
Charging the Rifle Scope
The rifle scope is equipped with a USB Type C port which is located under the
rubber cap on the right side of the rifle scope. Plug the included USB Type C
cable into a USB wall charger that has an output of 2 amps.
The rifle scope can be charged while it is powered On or Off, but it charges
faster in when powered Off. When in Recording Mode, the rifle scope will be
powered, but not charged.
Note : Using a wall charger with lower amperage will take longer to charge the
rifle scope.
1. Recommended charger is 2.0A USB charger
2. Battery charging time (from 0 to 100%) is 2 hours using a 2.0A USB charger
with the rifle scope powered Off
3. Battery run time is 6 hours on a single charge
MicroSD & USB C Ports
The rifle scope is equipped with a microSD Card
and USB (type C) ports. You can find them under
the rubber caps on the right side of the rifle scope.
To open the rubber port cover, gently lift the rub -
ber cover and move it out of the way.
Note : Make sure that the device is powered Off
before inserting the formatted MicroSD Card into
its port.
1. Always format a new microSD card before using
2. Insert the MicroSD card as shown
3. Use a thin object (small coin, paper clip) to fully insert and lock the MicroSD
in place in the slot
4. Close the rubber the cover
Note
: There is only one correct direction to insert the MicroSD card. Do not
force the microSD card into the slot as doing so may cause damage to both the
rifle scope and the MicroSD card.