8
If this unit fails to operate normally, check the following table. It lists the common operating errors and simple
measures which can correct them. If a problem cannot not be corrected, or the symptom is not listed,
disconnect the unit's power cord and contact your authorized Nissindo dealers or service centers for help.
Sometimes a failure (e.g. when buttons do not function) may be remedied by disconnecting the AC power
cord from the wall outlet and connecting it again, since this resets the unit's microcomputer.
SYMPTOM
Your voice is not heard
through the microphone.
The volume of the original
vocals cannot be reduced
even when the MPX BAL
control is turned to the
MUSIC side.
Your voice does not
replace the original vocals
when the VOCAL AID
button is pressed.
Sound from the playback
source cannot be heard.
The echo effect does not
work.
POSSIBLE CAUSE
Microphone plug is not firmly
inserted into the jack.
Microphone is turned off.
The MPX/STEREO button is not
set properly.
The volume level of the
microphone is low.
The singing voice is not loud
enough.
The INPUT selector is not set
properly.
MAGIC VOCAL is set to ON.
REMEDY
Insert firmly.
Turn on the power of the microphone.
With sound multiplex sources, set the
MPX/STEREO button to MPX. (The MPX indicator
lights)
With general stereo sources, set the
MPX/STEREO button to STEREO (the MPX
indicator goes off) and press the ONE TOUCH
KARAKE button. The MPX BAL control does not
function with these sources.
Turn up the volume of the microphone with the MIC
LEVEL control.
Sing louder.
Set it to the source to be played.
Turn off MAGIC VOCAL by pressing the MAGIC
VOCAL button.
TROUBLESHOOTING
NOTE
1
AA
AA
ALKALINE
BATTER
Y
ALKALINE
BATTER
Y
2
3
OPEN BATTERY COVER
Open the battery compartment cover on the back of the remote control unit.
The cover should be opened easily if you press on in with your thumb while
sliding it in the direction of the arrow.
INSERTING BATTERIES
Insert two size AA (R6) alkaline batteries (supplied) by matching the
+ and _ on the batteries to the diagram inside the battery
compartment.
CLOSE
BATTERY COVER
Close the cover of the battery case.
BATTERY INSTALLATION
1
2
3
Remove the batteries to avoid damage from possible
battery leakage whenever you anticipate that the remote
control will not be used for an extended period.
9
MAINTENANCE
Содержание KP-600
Страница 9: ...9 MAINTENANCE ...
