© 2017 Adolf Nissen Elektrobau GmbH + Co. KG
Construction and function
Variable Message Sign
13
3.4.3
Arresting bars
When opening the pivoting parts the variable message sign must be
secured in order to prevent lashing out due to e. g. wind gusts.
NOTE!
Opening the LED signs must only take place in a secured position.
3.4.4
Control housing
The control housing is located at the rear of the LED sign. The
control housing of the lower LED sign contains the master circuit
board and lowering and if existing the NiBus-modem circuit board.
3.4.5
Memory stick
The memory stick is located on the master circuit board in the
control housing of the LED signs. All image information including
previews for the remote control are contained in the memory sticks.
If a new image is needed for a LED sign, only the respective
memory stick must be replaced or overwritten with a new project .
All other components remain unchanged.
Before replacing memory sticks the message sign must always be
switched off with the main switch! Open the housing.
The locking screws must be loosened and the memory stick must
be removed. Then insert a new memory stick and tighten the
locking screws again. Close the housing. The sign can be activated
again (switch on the main switch). Own texts and symbols can be
created using a special software (extra accessories) and stored on
the memory stick. The connection to the PC is established via the
USB interface and a special USB adapter.
NOTE!
Is a memory stick changed or reprogrammed take care that the memory stick contains the right project! There
are different sign sizes with different projects. Up to max.250 different symbols are contained in up to one
memory stick.
ATTENTION
Before replacing memory sticks the message sign must always be switched off with the main switch!
Содержание VarioSign Series
Страница 2: ......
Страница 38: ......
Страница 39: ......
Страница 43: ...2017 Adolf Nissen Elektrobau GmbH Co KG Dimensions Variable Message Sign 43...