5
AU
Telephone Helpline: 1300225960
Cleaning, Care & Maintenance
•
Always switch off and disconnect the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the lid seal with warm water only.
• Always wipe dry after cleaning.
Note: Condensation will form in refrigeration with frequent opening of the lid and on hot humid days,
please ensure condensation is allowed to drain properly or is wiped dry.
Manual defrost
Nisbets Essentials recommend defrosting the appliance when any frost build up inside the freezer reaches
5mm thick.
1. Turn the freezer off and disconnect it from the power supply.
2. Remove food and shelving basket.
3. Put a water container underneath the drain hole at the left lower part of the front. Then unscrew the 2
drain hole covers (one inside the compartment; the other on the front housing).
4. Let the inside frost melt naturally. Wipe off any residue water.
5. When defrost done, put back the drain hole covers.
Troubleshooting
If your Nisbets Essentials appliance develops a fault, please check the following table before making a call to
the Helpline or your Nisbets Essentials dealer. A Nisbets Essentials agent or qualified technician must carry
out repairs if required.
Fault
Probable Cause
Solution
The appliance is not
working
The unit is not switched on
Check the unit is plugged in correctly and
switched on
Plug or lead is damaged
Replace plug or lead
Mains power supply fault
Check mains power supply
The appliance
turns on, but the
temperature is too
high/low
Too much ice on the evaporator
Defrost the appliance
Condenser blocked with dust
Clean the Condenser
Lid not shut properly
Check lid is shut and seals are not damaged
Appliance is located near a heat source
or air flow to the condenser is being
interrupted
Move the freezer to a more suitable location
Ambient temperature is too high
Increase ventilation or move appliance to a
cooler position
Appliance is overloaded
Reduce the amount of food stored in the
appliance
The appliance is
unusually loud
Loose nut/screw
Check and tighten all nuts and screws
The appliance has not been installed in
a level or stable position
Check installation position and change if
necessary
Difficult to open the
lid
Vacuum created by pressure
differences
Allow 20-30 seconds for pressure to
equalise
DA536-A_A5_v1_20211214.indb 5
DA536-A_A5_v1_20211214.indb 5
2021/12/14 10:53
2021/12/14 10:53
